Posts
Mold can begin to grow within 24 to 48 hours after water damage, according to the EPA. That window is why the first two days matter so much. If you stop the water, pull out soaked materials, and dry the space fast, you give mold very little chance to settle into your walls, floors, and…
The most common electrical fire warning signs are outlets or switch plates that feel warm or look discolored, lights that flicker or dim, breakers that trip or fuses that blow often, a burning or hot plastic smell, and buzzing or crackling sounds. If you notice any of these, stop using that circuit and call a…
After a leak or water loss, mold most often hides inside wall cavities, under carpet pad and flooring, behind baseboards, beneath sinks and appliances, in attics and ceiling spaces, and along basement walls. These spots stay damp long after surfaces look dry. A musty odor, soft or stained materials, and peeling paint are common clues.…
Before winter, test every smoke alarm and carbon monoxide alarm in your home, replace any smoke alarm that is 10 years old or older, and make sure you have CO alarms on every level and outside sleeping areas. NFPA recommends testing smoke alarms monthly. Fall is the right time to do a full check before…
Professional mold remediation follows a set process. A technician inspects the home and finds the moisture source, sets up containment to keep spores from spreading, runs HEPA air filtration, removes contaminated porous materials, cleans and treats what can be saved, dries the structure, and confirms the area is clean before rebuilding starts. Finding mold in…
Mold can begin to grow within 24 to 48 hours after water damage, according to the EPA. If wet drywall, carpet pad, or wood framing stays damp past the first two days, mold has what it needs to start spreading. Removing the water and drying the materials is the best way to stop it. If…
After a leak or water loss, mold most often hides where water collects and air does not move: inside wall cavities, under carpet pad and flooring, beneath sinks and cabinets, in attic insulation, behind basement finishes, around window frames, and inside HVAC components. These spots stay damp long after the visible water is gone. Once…
Professional mold remediation follows a set process: find and fix the moisture source, contain the work area, filter the air with HEPA equipment, remove mold-damaged porous materials, clean remaining surfaces, dry the structure, and confirm the area is clean before rebuilding. The IICRC S520 standard lays out these steps so the job is done the…
Cooking is the leading cause of home fires, per the NFPA. To prevent one, stay in the kitchen while you fry, grill, or broil, and keep flammable items away from the stove. If a small grease fire starts, slide a lid over the pan, turn off the heat, and never use water. If it spreads,…
Mold can begin to grow within 24 to 48 hours after materials get wet, according to the EPA. That window starts the moment water soaks into drywall, carpet pad, wood, or insulation. If you dry those materials fully inside that window and fix the source of the water, you give mold very little chance to…